USAlert NP-30 User Manual

NP-30
Numeric Pager
USER MANUAL
www.usalertllc.com
Copyright © USAlert, LLC 2002 All Rights Reserved
Contents
Section Chapter
(1) Introduction
(2)

Features

(3)

Icon Description

3.1 Icon Location
3.2 Icon Explanation
(4) Function Setting
4.1 To Turn The Pager On
4.2 To Turn The Pager Off
4.3 Alert Mode Setting
4.4 Set Mute(Vibration) Mode
4.5 Date and Time Setting
(5) Message Management
5.1 Read Message
5.2 To Delete All Messages
5.3 To Delete an Individual Message
5.4 Error Message
5.5 Memory Full
(1) Introduction
1. Display: 1 line display
20 digits per message / 12 digits per line with rollover data
2. Memory: 16 messages
3. All of the NP30 numeric pager functions are activated through the use of one switch, making it the easiest pager to
operate.
4. Displays the number and time of the message received at the end of the message.
5. Vibration, tone, or melody alert
6. Unread message indicator
7. Delete all/one message
8. When the capacity of messages is over 16 messages, the screen will show "full". The oldest message will be deleted
automatically.
9. Time display can be set in 12 or 24 hours
10. 7 different alerting tones
11. Displays error and repeat message automatically
12. Built-in spare power. When you are changing the battery, or the power is shut off accidentally, messages will be stored
in the memory to prevent loss of messages within 20 seconds. After 20 seconds, the message is lost and time must be
reset.
1.866.TWO.TONE
1
2
(2)Features

Battery safety

1. One AA alkaline battery is required for operation.
2. Battery Installation:
Unlock the battery compartment door by sliding the battery door lock in the opposite direction of the
arrow.
Slide the battery door open.
Insert one AA alkaline battery, observing the proper polarity.
Replace the battery door and lock into place.
3. Installing the battery will turn the pager on. The pager will enter a self-test mode by emitting one
short beep and vibration and the red LED lamp will turn on for 4 seconds. The pager will display
"NP30" on the screen.
(3) Icon Description
3.1 Location
1 2
3.2 Icon Explanation
1. Available range indication
2. Date
3. Time
4. Unread message
5. Alert mode: A speaker symbol will display when in the alert mode.
6. Next page: The "next page" ICON will display if there is any roll over data.
(4) Function Setting
4.1 To turn the pager on:
Insert the battery.
Slide the switch to the "N" position to turn the pager on.
The LCD will display "NP30" for 2 seconds and a speaker icon to denote the pager is on and ready
to receive messages. The LED will flash green every 5 seconds to indicate pager readiness.
3
3 4
5
6
4