Watchguard Firebox T55 Hardware Manual page 6

Fail Over
The Fail Over indicator is lit when there is a WAN failover from the primary external interface to the
backup interface. After the external interface connection fails back to the primary external interface,
the indicator is not lit.
WAP
On the Firebox T55-W models, the WAP indicator is lit when the appliance is activated as a wireless
access point or a wireless client. The color indicates the active wireless radio band.
Indicator Indicator Color
Yellow
Blinks (speed of blink increases as the data flow increases)
WAP
Green
Blinks (speed of blink increases as the data flow increases)
Network Interface Status Indicators
The Firebox T55 has five network interfaces. There are two status indicators for each interface.
Indicator Indicator Color
Yellow
1000
Blinks (speed of blink increases as the data flow
increases)
Green
10/100
Blinks (speed of blink increases as the data flow
increases)
Status
The Status indicator is lit when there is a management connection to the device. The Status indicator
is lit for 30 seconds after you connect to the device with the Fireware Web UI or the command line
interface. It is also lit when the device is polled by WatchGuard System Manager.
Mode
The Mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot send traffic to the external network.
Attn
The Attn indicator is yellow when you start the device with the Reset button pressed. For more
information, see
WatchGuard Technologies, Inc.
Restore Factory Default Settings
WatchGuard Firebox T55/T55-W Hardware Guide
Interface Status
Link speed: 1000 Mbps
Data sent and received
Link speed: 10 Mbps or 100
Mbps
Data sent and received
.
Wireless Band
2.4 GHz radio band
Data sent and received
5 GHz radio band
Data sent and received
3