Table of Contents
Advertisement
Chapter 7 VMR-O Cable Connection
This chapter describes how the signal and power cables of the VMR-O HD Series are
connected.
7.1 VMR-O HD series product cabinet interface introduction
Picture 7-1 VMR-O Cabinet Connection Port
① Power Output
② Power Input
③ Signal Output/Input
④ Signal Output/Input
Note: The Seetronic head is used for the 1-4 interface. All electrical parameters refer
to its specifications.
②power interfaces are strictly differentiated between input and output. When
① 、
cascaded, the output interface of the cabinet is connected to the next cabinet input.
③、④signal interface is the RJ45 interface. These two interfaces are independent of
input and output. After the signal is connected, the system receiving card will
automatically recognize the signal input or input.
26 / 66
Advertisement
Table of Contents
