Advertisement
SH-BLOX-OT24XX
THANK YOU FOR CHOOSING XYLEM
Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don't
hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
The appearance of your vanity may differ from the illustrations in this guide. This instructions still apply. Please ensure the finished wall
is straight and plumb and the floor is flat and perpendicular to the finished wall.
SUGGESTED TOOLS AND MATERIALS
Philips Screwdriver
ROUGH-IN DIMENSIONS
5-1/2"
(140mm)
FLOOR
TM
SH-BLOX-OT30XX
Level
Model #
SH-BLOX-OT24XX
SH-BLOX-OT30XX
SH-BLOX-OT36XX
SH-BLOX-OT48XX
X
SH-BLOX-OT36XX
Drill
X (inch)
24"
30"
36"
48"
SUGGESTED HEIGHT:
Application
Y (inch)
Undermount
28.5"
Vessel
25.5"
SH-BLOX-OTxxXX
SH-BLOX-OT48XX
10'
Tape Measure
Safety Glasses
21-1/2" (546mm)
Y (inch)
BLOX
TM
CONSOLE
FINISHED
WALL
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Xylem SH-BLOX-OT24 Series
Summary of Contents for Xylem SH-BLOX-OT24 Series
- Page 1 SH-BLOX-OT24XX SH-BLOX-OT30XX THANK YOU FOR CHOOSING XYLEM Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
- Page 2 • Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will cause white spots in the finish. Please note that some chemicals may damage the finish. Rev 2/10 For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time...
Need help?
Do you have a question about the SH-BLOX-OT24 Series and is the answer not in the manual?
Questions and answers