Download Print this page

Xylem BLOX V-BLOX-SH-20 series Installation Instructions

Vanity

Download this manual

THANK YOU FOR CHOOSING XYLEM

Please take a few minutes to review this manual before you start installation. If you

encounter any installation problems, please don't hesitate to contact us.

Before you begin, please observe all local building codes. Unpack the new product and

inspect for damage. The appearance of your vanity may differ from the illustrations in this

guide. This instructions still apply.

Please ensure the finished wall is straight and plumb and the floor is flat and perpendicular

to the finished wall.

SUGGESTED TOOLS AND MATERIALS

Philips Screwdriver

ROUGH-IN DIMENSIONS

FLOOR

Level

20" (508mm)

Y (inch)

Drill

SUGGESTED HEIGHT:

Application

Y (inch)

Undermount

14"

Vessel

11"

INSTALLATION INSTRUCTIONS

V-BLOX-SH-20xx

10'

Tape Measure

Safety Glasses

FINISHED

21-1/2" (546mm)

BLOX

VANITY

WALL

Page 1: Installation Instructions
BLOX VANITY V-BLOX-SH-20xx THANK YOU FOR CHOOSING XYLEM Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
Page 2 WALL PREPARATION Notch studs 1-1/2" (38mm) to provide support for header. Extend the header beyond the countertop to the nearest stud. 2” x 12” Header SUGGESTED HEIGHT: Application Z (inch) Undermount 35” Finished Wall Vessel 32” INSTALLATION INSTRUCTIONS Remove wood supports from the back of vanity.
Page 3 INSTALLATION INSTRUCTIONS HARDWARE INCLUDED Level the vanity with a leveler and attach the brackets to the 2 x 12 header using screws provided. CARE AND CLEANING • To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units.
Page 4 ADJUSTMENT SIDE CAM HEIGHT TILT Rev 2/10 For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time...