D-Link DWL-G510 Quick Installaion Manual page 8

Appendix (Cont.)
G. SSID: The Service Set
Identifier is the name as-
signed to the wireless
network. The factory SSID
setting is set to default. Make
changes here to match the
SSID on existing Wireless
Router or Access Point.
J. Channel: By default, the
channel is set to 6. Channel
selection is automatically
adjusted by the DWL-G510
depending on the channel
setting of the access point
selected for association. To
change the channel settings,
the Wireless Mode must be
set to Ad-hoc.
H. Wireless Mode:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is used
for peer-to-peer
networking.
G
H
I
J
K
L
K. TxRate:
adjust the transmis-
sion rate to get the
best signal possible
depending on your
usage and your
environment.
I. AdHoc Band:
Ad-Hoc Band used whether
802.11b/g when setting up an
Ad-Hoc network.
You can
L. Power Mode:
Power Mode is set to
Continuous Access Mode.
Continuous Access Mode —
this default setting con-
sumes the most power.
Maximum Power Save —
this setting consumes the
least power. Power Save —
this setting consumes a
moderate amount of power.
8
Specifies the
By default,