Connecting With The Pc - HP V206hz User Manual

Connecting the Display

Connecting with the PC

1.
Before setting up the monitor, ensure that the power to the monitor, the computer
system, and other attached devices is turned off.
2.
Connect signal input cable 1 and power cord 2 in order, then tighten the screw
of the signal cable.
Connect DVI-D(Digital signal) Cable
A
B Connect D-sub(Analog signal) Cable
NOTE
This is a simplified representation of the rear view.
This rear view represents a general model; your display may differ from the view as shown.
If the signal cable is disconnected, your monitor will turn off automatically after a period.
Wall-outlet
type
3. Press the power button on the front panel to turn the power on. When monitor power is
turned on, the 'Self Image Setting Function' is executed automatically.
(Only Analog Mode)
NOTE
' Self Image Setting Function'? This function provides the user with optimal display settings. When
the user connects the monitor for the first time, this function automatically adjusts the display to
optimal settings for individual input signals.
'AUTO' Function? When you encounter problems such as blurry screen, blurred letters, screen
flicker or tilted screen while using the device or after changing screen resolution, press the AUTO
function button to improve resolution.
Varies according
to model.
DVI-D (This feature is
not available in all
countries.)
B A
Power Button
E56
When using a D-Sub signal input
cable connector for Macintosh:
Mac adapter : For Apple
Macintosh use, a separate plug
adapter is needed to change the
15 pin high density (3 row) D-sub
VGA connector on the supplied
cable to a 15 pin 2 row
connector.
Connect the signal
input cable and tighten
it up by turning in the
PC
direction of the arrow
as shown in the figure.
PC
PROCESSING SELF
IMAGE SETTING