Connecting The DWL-2700AP Wireless
Access Point To Your Network
Hardware Installation Overview
Step 1:
Do the Physical Installation first (Please refer to pages 4-8).
Step 2:
Connect the remaining end of the supplied Ethernet cable (Connected to the
DWL-2700AP in Step 1 on page 4) to the P+ DATA OUT port on the PoE base unit.
Step 3:
Connect a straight through Ethernet cable from a router/switch to the DATA IN
port on the PoE base unit. If connecting directly to a PC instead of a router or switch,
then a crossover Ethernet cable must be used.
Step 4:
Attach the power adapter to the connector labeled POWER IN on the PoE
base unit. Attach the power cord to the power adapter and into an electrical outlet.
11