Battery Installation For Remote Control - DBPOWER SBB-55210 User Manual

BATTERY INSTALLATION FOR REMOTE CONTROL

Battery installation:
1. Press and slide out the battery door as shown in Fig.1.
2. Replace the battery with a new CR2025(3V) button cell with the polarity marking
upward as shown in Fig.2.
Fig.1
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
2. Be sure to follow the correct polarity when installing the battery as indicated in
the battery compartment, a reserved battery may cause damage to the device.
or old battery with fresh ones.
period of time, remove the battery to prevent damage or injury from possible
leakage.
5. Do not try to recharge the battery as it is not intended to be recharged; it can
overheat and rupture. ( Follow the battery manufacturer's instructions.)
7. Clean the battery contacts and also those of the device prior to battery
installation.
8. The remote control is supplied with a coin/button cell
battery. If the coin button cell battery is swallowed, it
can cause severe internal burns in just 2 hours and can
lead to death. Keep new and used battery away from
children. If the stop using the product and keep it
3V CR2025
Fig.2
5
Fig.3
CR2025