Related Manuals for Sencor SWD R130
Summary of Contents for Sencor SWD R130
- Page 1 SWD R130 Receiver - Doorbell - user manual Receiver - Zvonek - návod k obsluze Receiver – Zvonček – návod na obsluhu Receiver - Csengő - használati útmutató Receiver – Dzwonek – instrukcja obsługi...
- Page 3 Installation Test Negative Open the packaging, remove the battery insulation foil and close the battery compartment. Please make sure that the negative pole of the battery is facing upwards and the positive pole of the battery downwards. Sticking Take out the supplied double-sided adhesive tape, remove the sticker from one side and stick it correctly on to the bottom surface of the transmitter.
- Page 4 The button may also be permanently mounted using screws. Pre-marked screw holes are located on the inside of the cover. These can be used if you wish to permanently install the doorbell button. It is necessary to seal the holes under the screw head so that water does not enter through them.
- Page 5 Setting the learning code 1. Delete the prior code: Because pairing is already set by the manufacturer, this task is only necessary for repair in the event that the learning code is lost. If you need to delete the codes, please hold down concurrently the volume setting button and music selection button for three second.
-
Page 6: Troubleshooting
Circuit design Isolation of high and low Compatibility with safety voltage circuits requirements (relates to the AC receiver) Radio frequency 433 MHz Troubleshooting Error Cause Remedy Notes Transmitter Batteries are Check the positive Battery type indicator is not inserted and negative poles CR 2032 may also not lit correctly... - Page 7 Directive 1999/5/ES. The device can be operated in the EU without restriction. The declaration of conformity is a part of the user's manual or can be found at the website www.sencor.eu. Changes in the text, design and technical specifications may change without prior notice and we reserve the right to make these changes.