LG FB-C186HSA0 Installation Instructions Manual page 10

WIERED REMOTE CONTROLLER INSTALLATION
• Since the room temperature sensor is in the remote controller, the remote controller box
should be installed in a place away from direct sunlight, high humidity and direct supply of cold
air to maintain proper space temperature.
Install the remote controller about 5ft(1.5m) above the floor in an area with good air circulation
at an average temperature.
Do not install the remote controller where it can be affected by:
- Drafts, or dead spots behind doors and in corners.
- Hot or cold air from ducts.
- Radiant heat from sun or appliances.
- Concealed pipes and chimneys.
- Uncontrolled areas such as an outside wall behind the remote controller.
- This remote controller is equipped with a seven segment LED. display. For proper display of
the remote controller LED's, the remote controller should be installed properly as shown in
Fig.1.
(The standard height is 1.2~1.5 m from floor level.)
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
N
TIO
B FU NC t
SU Pre hea ify
D ate r mid r
SP EE He Hu t t doo
N AUT O De fros Ou 4
FA JET Filt er 3
MP HI 1 2
T TE p MED
SE m Tem LO 23
IO N Roo NE
AT ZO 21
ER 19
OP e 17
ING Ti m 15
SW m set
TO gra 13
AU Pro 11
09
t 07
tion uni
Op era 05
03
er f 01
Tim Of e Tim
On no.
Set
no
Fig.1 Typical locations for remote controller
yes
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
Time ZONE 1 2 3 4
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15 17 19 21 23
no
5feet
(1.5meters)
10