Multi-Mover S15 User Manual And Parts List

Multi-Mover S15 User Manual And Parts List

500w 24vdc
Hide thumbs Also See for S15:

Advertisement

Quick Links

Transport
* Only use stable loading surfaces with sufficient loading capacity (see section 2.2).
* Secure the MULTI-MOVER S against tilting or sliding.
* It is prohibited to;
-
get under the MULTI-MOVER S while lifting
-
remain within the tilting range of the MULTI-MOVER S during unloading
MULTI-MOVER S15
USER MANUAL and PARTS LIST
MULTI-MOVER S15
500W 24VDC
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S15 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Multi-Mover S15

  • Page 1 * Only use stable loading surfaces with sufficient loading capacity (see section 2.2). * Secure the MULTI-MOVER S against tilting or sliding. * It is prohibited to; get under the MULTI-MOVER S while lifting remain within the tilting range of the MULTI-MOVER S during unloading MULTI-MOVER S15...
  • Page 2: Table Of Contents

    Chapter 9 PARTS Chapter 10 DECLARATION OF CONFORMITY Appendix I Exploded view Appendix II User manual battery charger Multi-Mover Europe B.V. www.multi-mover.eu T +31 24 744 00 70 F +31 24 890 17 90 T +49 2841 999 8083 MULTI-MOVER S15...
  • Page 3: Introduction / Warranty / Definitions / Safety Symbols

    The user manual should be made available to the user of the Multi-Mover S and must be present at the Multi-Mover S15 when it is being used. The user manual must have been read by anyone working with/at the Multi-Mover S15, and the instructions must be observed.
  • Page 4: Chapter 2 Technical Description

    Safety symbols On various places on the Multi-Mover S15 you will find standardized safety symbol stickers as displayed to the right. The upper part warns against a general or particular hazard. The lower part indicates what type of hazard is being warned against and will explain what you must do.
  • Page 5: Packaging, Loading / Unloading, Towing, Recycling

    Avoid injury and damage as a result of incorrect placement of the lift truck's lift forks. Loading and unloading If the Multi-Mover S15 has to be moved by means of a lift truck, the lift forks must be placed at the heaviest part at the rear of the Multi-Mover S15, between the 2 large wheels.
  • Page 6: Chapter 3 Safety Regulations

    Never drive onto a slope at an angle or crosswise. Only ever drive on and off a slope at a right angle. The Multi-Mover S with trailer(s) may also tip over if the bends are taken at a speed that is too high.
  • Page 7 Make sure the trailer(s) has/have been loaded evenly and safely. 3.11 Caution! Wear clothing that allows you to move freely and does not hinder your view on the Multi-Mover S plus trailer(s). Observe your company's safety regulations. Wear safety shoes 3.12 Caution! Hazard of injury.
  • Page 8 Multi-Mover S, temporary personnel for instance. The MULTI-MOVER S may only be operated after the operator has thoroughly studied the user manual and after the owner of the Multi-Mover S has provided a full training / instruction concerning the operation and the safety regulations.
  • Page 9: Chapter 4 Preparation

    For other applications, the CE mark does not apply. The electric components and wiring have been made drip-proof IP52. Therefore, the Multi-Mover S15 must be covered in case of sprinkling or spraying plants. The Multi-Mover S15 must also be stored on a dry location.
  • Page 10: Responsibility Operator

    - check the jam safety on the steering handle by pressing the safety switch (1, fig. 9), the Multi-Mover S15 should not start in that case. If you establish a fault, or if you have any doubts concerning the operation of the Multi-Mover S you must immediately report this to your supervisor or the maintenance personnel.
  • Page 11: Regulations For Use

    Avoid bends if necessary and be careful on small hills, thresholds, etc. Reduce speed in case of sharp bends. The Multi-Mover S may only be driven at speeds that allow you to stop in time, e.g. if an obstacle is standing in or entering the driving area.
  • Page 12: Operation

    Type plate Steering handle (Tillerhead) 10 Potentiometer maximum speed adjust- Swivel wheel ment Charger cable 230V 11 Option Driving wheel with solid tyre 12 Horn 13 Steering bar Forwards/Backwards Throttle Belly Button Emergency STOP 14 Hinge point steering bar MULTI-MOVER S15...
  • Page 13: Batteries

    If the button is pressed down, the Multi-Mover S can only be driven electrically. Steering handles (4) The steering handle (4) with bar is a fixed part of the Multi-Mover S, moving to the left means driving to the left, and vice versa.
  • Page 14 For a longer life span, it is better not to allow the battery to get completely empty. It is also not good to continue charging a battery that is almost full. If the Multi-Mover S is out of operation (for a longer period), we recommend keeping the battery charger connected, it will automatically keep the battery in a charged condition.
  • Page 15 We therefore recommend recharging the stored Multi-Mover S every 2 months. It is also possible, that there are still standby consumers in a switched off Multi-Mover S (key ignition etc.), which will mean that the batteries will discharge more quickly.
  • Page 16: Coupling Trailer(S)

    Maximum slope angle, with / without load 10 / 20 % Slowly reverse the Multi-Mover S15 to the pole of the trailer and place the tow eye or coupling of the pole between the tow eyes, hitch or coupling point of the Multi-Mover S and insert the tow pin. Then secure the tow pin with a spring clip.
  • Page 17: Annual Maintenance

    Multi-Mover S on blocks, so that the tyres do not touch the ground Have maintenance and repairs performed by persons authorized by Multi-Mover Europe BV. In case of doubt, always consult your supplier. For the above-mentioned maintenance instructions, we assumed normal use.
  • Page 18: Chapter 8 Failures

    FAILURES When removing a failure, ALWAYS switch off the Multi-Mover S and remove the ignition key. If a defect is established at the Multi-Mover S15, do not use it until the repair has been completed. Failure Solution The Multi-Mover S15 does not drive.
  • Page 19: Chapter 10 Declaration Of Conformity

    We, Multi-Mover Europe BV, Boomsestraat 38, 6613 AH Balgoij, Netherlands declare at our own full responsibility, that the Multi-Mover S15 ***, with serial number 2018*** to which this declaration applies, is in conformity with the provisions of the following directive(s):...

Table of Contents