DRAIN INSTALLATION
1. Remove strainer from strainer body by loosening the screw.
2. Apply appropriate sealant around the underside of the strainer
body according to manufacturer's instructions.
3. Align the drain ell, and rubber gasket underneath the bath
drain hole, and carefully thread strainer body into the drain ell.
4. Align the drain ell to point toward the overflow the bath.
5. Insert the handles of a pliers into the strainer body, and
tighten securely. Remove excess putty.
6. Install the strainer to the strainer body by tightening the
screw.
7. Insert the handles of a pliers into the strainer body, and
tighten securely. Remove excess putty.
8. Install the strainer to the strainer body by tightening the
screw.
9. Put rubber gasket on to overflow ell using channel in gasket,
wrap around overflow ell flange. Opening should be on the
bottom.
REVISED 4.27.2018
JACLO.COM
| PG 2
j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 | 800.852.3906
FIG. 1
FIG. 2
FIG. 3
FIG. 4
f 908.653.1717 | 800.852.4133