D-Link DE-220PCT User Manual page 14

DE-220P Series Ethernet Adapter / User's Guide
2. The cable will have an RJ-45 plug on each
end.
the
other end into an available port of a 10Base-T
hub.
until its retainer snaps into place.
The Network Medium is Thin
Coaxial Cable
Connect a BNC T-connector onto the BNC recep-
tacle of the DE-220P Series card.
Connect the network feed cable onto either open
end of the BNC T-connector.
3a. If the cable continues on to an additional station
or stations,
onto the remaining open end of the BNC T-
connector.
3b. If the network cable does not continue to addi-
tional stations (your computer is at the end of the
cable), then connect a 50-ohm terminator to the
remaining open end of the BNC T-connector.
14
Plug one end into the RJ-45 receptacle of
DE-220P Series
Push each RJ-45 plug into its receptacle
then connect
adapter, and
the continuation
plug the
cable
Installation