Advertisement
DE-220P Series Ethernet Adapter / User's Guide
Multiple Cards in a Non-PnP
System
In non-PnP systems, the procedure for configuring
multiple DE-220P Series cards is basically a se-
quence
make a preliminary installation of each card alone
in turn, make a setup.exe run to configure that
card, then remove that card and go on to the next.
CAUTION:
The following procedure involves operation of the
computer without its chassis housing in place. Caution
is necessary in order to avoid contact with exposed
high-voltage parts. Accidental contact with exposed
internal parts can cause personal injury, and can cause
damage to the computer equipment.
1. Make a preliminary installation of the first DE-
220P Series card by completing Steps 1 through 3
as set out in the "Single-Adapter Installation" sec-
above.
2. Restore power to the computer, and configure the
card
by
setup.exe.
settings that you select, to help you select different
settings in configuring the remaining cards.
3. Shut down the computer and unplug its power
cord.
the
next
expansion slot.
4. Restore power to the computer, and configure the
card
by
10
of
separate
running
Make a note of the configuration
Remove the (configured) card, and install
DE-220P
running
single-adapter
the
supplied
Series
card
the
supplied
procedures:
setup
program,
into
any
open
setup
program,
Installation
tion
Advertisement
