Craftsman 944.364151 Owner's Manual page 7

HONDA 4-CYCLE ENGINE
MODEL NUMBER GCV160-LAOS3B
26
TO ASSEMBLE GRASS CATCH ER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
Vinyl
bindings opening
INSTALL STARTER ROPE
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until
rope will slip into loop of rope guide.
4. Tighten T-knob.
Frame
handle
Control bar
Upper handle
Frame
Rope guide T-Knob
Engine
starter rope
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to
be used as a mulcher. To convert to bag-
ging, see "TO CON VERT MOW ER" in the
Operation section of this man u al.
7