Program End; Canceling The Program - Beko DU 7133 GA0 User Manual

1. For example, to select Extra Dry program
instead of the Iron Dryness, stop the
program by pressing the Start / Pause
button.
2. Turn the Program Selection knob to select
the Extra Dry program.
3. Start the program by pressing the Start /
Pause button.
Adding and removing laundry in stand-by
mode
If you want to add or remove laundry after the
drying program starts:
1. Press the Start/Pause button to take the
machine into Stand-by mode. Drying
operation stops.
2. Open the loading door, add or remove
laundry and close the loading door.
3. Start the program by pressing the Start /
Pause button.
C
NOTE
• The laundry adding made after the drying
operation started may cause the dried
laundry inside the machine to mix with
the wet laundry and the laundry to remain
damp after the operation ends.
• If a new program is selected by changing
the position of the program selection
knob while your machine is in stand-by
mode, the running program ends.
• Laundry adding and removing can be
repeated as much as desired during
drying operation.But this process
would continuously interrupt the drying
operation, and so would cause the
program duration to lengthen and
increase energy consumption. Thus, it is
recommended to add laundry before the
program starts.
WARNING!
• Do not contact the inner surface of the
drum when adding or removing laundry
during a continuing program. The drum
surface is hot.

5.12 Canceling the program

If you want to cancel the program and end
the drying operation for any reason after the
machine starts running, press the On/Off
button.
Dryer / User Manual
A
WARNING!
• As it will be extremely hot inside the
machine when you cancel the program
while the machine is in operation; run the
ventilation program to cool it down.

5.13 Program end

When the program ends, the Final/Wrinkle
Prevention, Fiber Filter Cleaning and Water
Tank Warning leds on the program follow up
indicator light up. Loading door can be opened
and machine becomes ready for a second run.
Press the On/Off button to turn off the
machine.
C
NOTE
• In case the laundry is not removed after
the program is completed, the wrinkle
prevention program that lasts 2 hours
start in order to prevent wrinkling of the
laundry that remains inside the machine.
• Clean the fiber filter after each drying.
(See. „Fiber filter and loading door inner
surface")
• Empty the water tank after each drying.
(See. „Emptying the water tank")
15