Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Chauvet DJ COREpar 80 USB
Summary of Contents for Chauvet DJ COREpar 80 USB
- Page 1 User Manual...
-
Page 2: Table Of Contents
Master/Slave Mode (wired) ......................16 Master/Slave Mode (D-Fi USB) ....................16 4BAR Tri USB Expansion ........................16 5. Maintenance .........................17 Product Maintenance ........................17 6. Technical Specifications ....................18 Returns ..........................19 Contact Us .........................20 Page 2 of 20 COREpar 80 USB User Manual Rev. 2... - Page 3 COREpar 80 USB User Manual Rev. 2 Page 3 of 20...
-
Page 4: Before You Begin
© Copyright 2015 Chauvet & Sons, LLC. All rights reserved. Electronically published by Chauvet in the United States of America. CHAUVET, the Chauvet logo, “COREpar 80 USB”, “D-Fi USB”, and “4BAR Tri USB” are registered trademarks or trademarks of Chauvet & Sons LLC. (d/b/a Chauvet and Chauvet Lighting) in the United States and other countries. -
Page 5: Product At A Glance
Keep this User Manual for future use. If you sell the product to someone else, be sure that they also receive this document. COREpar 80 USB User Manual Rev. 2 Page 5 of 20... -
Page 6: Introduction
Power Out Pass Through Back Panel View WARNING! DO NOT plug anything other than a D-Fi USB into the USB port. Doing so may cause damage to the product. Page 6 of 20 COREpar 80 USB User Manual Rev. 2... -
Page 7: Product Dimensions
Product Dimensions 9.9 in 253 mm 5.6 in 143 mm 7.9 in 200 mm COREpar 80 USB User Manual Rev. 2 Page 7 of 20... -
Page 8: Setup
Fresnel Lens AC Power The COREpar 80 USB has an auto-ranging power supply and it can work with an input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart. -
Page 9: Power Linking
Product Additional Products You can power link up to 7 COREpar 80 USB products on 120 VAC or up to 13 COREpar 80 USB products on 230 VAC. The power linking diagram corresponds to the North American version of the... -
Page 10: Mounting
Before mounting the product, read and follow the safety recommendations indicated in Safety Notes. Orientation The COREpar 80 USB may be mounted in any position; however, make sure adequate ventilation is provided around the product. · Rigging Before deciding on a location for the product, always make sure there is easy access to the product for maintenance and programming purposes. -
Page 11: Operation
(custom colors) Combines red, green, and blue b 0–255 dIM1 Dimmer speed mode, fast to slow, or off dIM2 dIM3 IR function on or off teMP Displays the product temperature COREpar 80 USB User Manual Rev. 2 Page 11 of 20... -
Page 12: Dmx Linking
The COREpar 80 USB works with a DMX controller. Information about DMX is in the DMX Linking CHAUVET® Primer, which available from Chauvet website http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf. Set the product in DMX mode to control with a DMX controller. Configuration Connect the product to a suitable power outlet. -
Page 13: Dmx Personality And Starting Address
Address The COREpar 80 USB uses up to 8 DMX channels in an 8-CH DMX mode, which defines the highest configurable address to 505. If you are not familiar with the DMX protocol, download the DMX Primer from www.chauvetlighting.com. -
Page 14: Configuration (Standalone)
The product will only respond to low frequencies of music (bass and drums). Sound Sensitivity To change the sound sensitivity on the COREpar 80 USB, follow the instructions below: Press <MENU> repeatedly until SenS shows on the display. Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u 0–100). -
Page 15: Irc-6 Infrared Remote Control
The COREpar 80 USB is compatible with the IRC-6 infrared remote control from IRC-6 Infrared Chauvet. To activate IR mode, follow the instructions below: Remote Press <MENU> repeatedly until SEr shows on the display. Control Press <ENTER> to accept. Press <UP> or <DOWN> to select On or OFF. -
Page 16: Master/Slave Mode (Wired)
The COREpar 80 USB can act as part of an expansion for the 4BAR Tri USB. For 4BAR Tri USB instructions on configuring the product for 4BAR Tri USB Expansion mode, see the User Expansion Manual for the 4BAR Tri USB. -
Page 17: Maintenance
Softly drag any dirt or grime to the outside of the transparent surface. Gently polish the transparent surfaces until they are free of haze and lint. Always dry the transparent surfaces carefully after cleaning them. COREpar 80 USB User Manual Rev. 2 Page 17 of 20... -
Page 18: Technical Specifications
Maximum External Temp. Cooling System 104 °F (40 °C) Convection I/O Connectors Channel Range 3-pin XLR 3 or 8 Ordering Product Name Item Code UPC Number COREpar 80 USB 03031057 781462214050 Page 18 of 20 COREpar 80 USB User Manual Rev. 2... -
Page 19: Returns
Be sure to pack the product properly. Any shipping damage resulting from inadequate packaging will be your responsibility. FedEx packing or double-boxing are recommended. Chauvet reserves the right to use its own discretion to repair or replace returned product(s). COREpar 80 USB User Manual Rev. 2 Page 19 of 20... -
Page 20: Contact Us
Outside the U.S., United Kingdom, Ireland, Mexico, or Benelux contact the dealer of record. Follow their instructions to request support or to return a product. Visit our website for contact details. Page 20 of 20 COREpar 80 USB User Manual Rev. 2...