Table of Contents
Advertisement
SPRINT™ INFLATION SYSTEM
The SPRINT™ inflation system is a simple to use feature to quickly inflate your kite to an even
pressure. The SPRINT™ system uses a single inflation point to connect your high volume, two
way Cabrinha pump. As you pump your kite with air, all struts and your leading edge inflate
quickly and simultaneously to the desired pressure. The supplied leash pump and threaded
valve connection keeps your kite under control even when pumping up directly in the wind.
Once the kite is pumped you can choose to clip off the air to the struts. This way if you damage
a strut while in use, the rest of the kite will maintain its pressure. At the end of the session you
can choose to deflate your kite completely by disengaging the strut clips.
You can also keep your struts inflated and put your kite away rolled up so that the next session
will take just minutes to set up.
SINGLE INFLATION VALVE FILLS THE ENTIRE KITE WITH AIR
AIRLOCK™ INFLATION/DEFLATION VALVE
FIG. 2
FIG. 1
THE UPPER SECTION IS
THE INFLATION CAP
THE LOWER SECTION IS
THE RELEASE VALVE
2011 CROSSBOW IDS™ KITE USER MANUAL
SETUP
FIG. 3
11
Advertisement
Table of Contents
