Installing The Vanishing Edge; Tm Strainer; Installing The Bottom Grids - Westinghouse QK043G Owner's Manual

Installation (continued)

INSTALLING THE VANISHING EDGE

NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer
assembly. You will need to purchase a special adaptor that will replace the flange from
your garbage disposer. The flange adaptor is available from the manufacturer. Install
the garbage disposer according to the manufacturer's installation instructions replacing
the flange for the adaptor.
- Apply a small amount of plumbers putty (not included) in the notch around
the drain hole of the sink (A) .
- Connect the upper strainer body (3) and the strainer ring (4), and insert
them into the drain hole from the top of the sink (A) .
- Connect the strainer gasket (5) and lower strainer body (6), and insert them
into the drain hole from underneath the sink (A) .
- Insert the strainer screw (2) through the entire assembly, from the upper
strainer body (3) to the lower strainer body (6). Tighten with a flathead
screwdriver .
- Connect the plastic flange (7) and the tail pipe (8), and thread the
connecting nut (9) through the tail pipe and flange up to the lower strainer
body (6) . Tighten the connecting nut by hand .
NOTE:
The plastic flange (7), tail pipe (8), and connecting nut (9) are not supplied.

INSTALLING THE BOTTOM GRIDS

- Ensure that the vanishing edge
sinks (A) before placing the bottom grids (B) .
- The bottom grids (B) must be positioned with the rubber supports down .
Tilt the grids up so it is at a slight angle, slide them into the sink (A), and
place them so that they are sitting flat on the bottom of the sink..
TM STRAINER
TM strainer baskets (C) are already in the
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
A
A
11
1
2
3
4
5
6
7
8
Not supplied
9
C
B
CONGLOMKB .COM