Westinghouse QK043G Owner's Manual

Westinghouse QK043G Owner's Manual

Stainless steel dual bowl sink with rounded corners
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

OWNER'S MANUAL
MANUEL DE L'UTILISATEUR
STAINLESS STEEL DUAL BOWL SINK
WITH ROUNDED CORNERS
ÉVIER DOUBLE AUX COINS ARRONDIS
EN ACIER INOXYDABLE
# QK043G

Advertisement

Table of Contents
loading

Summary of Contents for Westinghouse QK043G

  • Page 1 STAINLESS STEEL DUAL BOWL SINK WITH ROUNDED CORNERS ÉVIER DOUBLE AUX COINS ARRONDIS EN ACIER INOXYDABLE OWNER’S MANUAL MANUEL DE L’UTILISATEUR # QK043G...
  • Page 2: Table Of Contents

    If you have any questions, contact the manufacturer . 3 . Installation work and plumbing must be done by qualified person(s) in accordance with all applicable codes and standards . 4 . Protect the entire surface during installation . QK043G...
  • Page 3: Warranty

    Warranty ONE-YEAR LIMITED WARRANTY A thorough inspection must be made before installation and any damage must be promptly reported . We will not be liable for failures or damage that could have been discovered or avoided by proper inspection and testing prior to installation . Conglom Kitchen &...
  • Page 4: Pre-Installation

    Silicone sealant Pencil Thread Seal Flathead Hacksaw Safety goggles screwdriver Safety gloves PARTS REQUIRED (NOT INLCUDED) NOTE: Plastic Connecting Tail pipe (2) Supply lines (2) flange (2) nut (2) Parts not shown to actual size. QK043G...
  • Page 5: Package Contents

    Pre-Installation (continued) PACKAGE CONTENTS Part Description Quantity Sink Template Stainless steel sink Bottom grids Vanishing edge strainer Strainer assembly Topmount clips Undermount clips CONGLOMKB .COM Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
  • Page 6: Installation

    - Make sure the template (1A) is parallel to the front of the counter . Setback Tape 3 1/2 - 4 in. (89 mm - 102 mm) Undermount installation QK043G...
  • Page 7 Installation (continued) TESTING THE FIT OF THE SINK DRILLING THE HOLES FOR THE UNDERMOUNT CLIPS - Place the sink (A) underneath the cut-out in the counter to CAUTION: Always wear safety goggles and gloves when test its fit. Ensure that the reveal is equal on all four sides using power tools to prevent personal injury .
  • Page 8 SUPPLY LINES (NOT INCLUDED) The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately . Follow the supply line manufacturer’s instructions for proper installation . QK043G...
  • Page 9: Topmount

    Installation (continued) TOPMOUNT INSTALLATION PREPARING THE AREA CUTTING THE COUNTER NOTE: CAUTION: Always wear safety goggles and gloves when Topmount sinks are dropped into the counter from above. If you are using power tools to prevent personal injury . installing an undermount sink, please see “undermount installation”. Sink template (1A) shows cut-lines for both undermount and topmount installations.
  • Page 10 SUPPLY LINES (NOT INCLUDED) The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately . Follow the supply line manufacturer’s instructions for proper installation . QK043G...
  • Page 11: Installing The Vanishing Edge

    Installation (continued) INSTALLING THE VANISHING EDGE STRAINER NOTE: If you are installing a garbage disposer (not supplied), do not install the strainer assembly. You will need to purchase a special adaptor that will replace the flange from your garbage disposer. The flange adaptor is available from the manufacturer. Install the garbage disposer according to the manufacturer’s installation instructions replacing the flange for the adaptor.
  • Page 12: Care And Cleaning

    ) . Always rub the surfaces in the direction of the grain of the steel . When finished, rinse the sink with water and dry it with a towel to allow the sink to form a protective outer layer. This procedure can also be used to renew all of the surfaces of the sink . QK043G...
  • Page 13: Service Parts

    Service Parts If you are missing parts or if you require replacement parts, please call our customer service team at cs@conglomkb .com or 1-877-333-0098, 8:30 am - 5 pm, EST Monday - Friday . Identify the required part(s) and have the part number(s) ready . Part Description Code Quantity...
  • Page 14: Manuel De L'utilisateur

    3 . Votre installation doit être conforme à tous les codes de bâtiment locaux pour la plomberie . Faites en sorte qu’un ouvrier qualifié effectue ou approuve votre installation de plomberie . 4 . Protèger la surface lors de l’installation . QK043G...
  • Page 15: Garantie

    Garantie GARANTIE LIMITÉE D’UN AN Inspecter minutieusement le produit avant l’installation et signaler tout dommage sans délai . Nous ne serons pas responsables des défaillances ou des dommages qui auraient dû être découverts ou évités par une inspection adéquate et des essais avant l’installation . Conglom Kitchen and Bath garantit ce produit contre tout défaut dans les matériaux ou la fabrication, pour une période d’un (1) an à...
  • Page 16: Préinstallation

    Scie à métaux Lunettes de sécurité Gants de sécurité PIÈCES REQUISES (NON INLCUSES) REMARQUE : Bride en Tuyau de Écrou de Tuyaux Les pièces ne sont pas plastique (2) vidange (2) raccordement (2) d’alimentation (2) illustrées à leur taille réelle. QK043G...
  • Page 17: Contenu De L'emballage

    Préinstallation (suite) CONTENU DE L’EMBALLAGE Pièce Description Quantité Gabarit pour l’installation Évier en acier inoxydable Grilles métalliques Crépine à rebord infini Assemblage de la crépine Attaches de fixation par le dessus Attaches de fixation par en dessous CONGLOMKB .COM Veuillez contacter cs@conglomkb.com ou 1-877-333-0098 pour toute assistance supplémentaire.
  • Page 18: Installation

    . - S’assurer que le gabarit (1A) est aligné parallèlement à l’avant du comptoir . Marge de recul Ruban 3 1/2 - 4 in. (89 mm - 102 mm) Installation sous le comptoir QK043G...
  • Page 19 Installation (suite) ESSAI DE L’AJUSTEMENT DE L’ÉVIER PERÇAGE DES TROUS POUR LES ATTACHES DE FIXATION PAR EN DESSOUS DU COMPTOIR - Placer l’évier (A) en dessous de la découpe dans le comptoir pour faire l’essai de son ajustement . Faire en sorte que la AVERTISSEMENT : Toujours porter des lunettes et des partie visible est égale sur les quatre côtés lorsque vue du gants de sécurité...
  • Page 20 Les tuyaux d’alimentation qui raccordent le robinet au système d’eau résidentiel ne sont pas fournis avec cette unité . Ils doivent être achetés séparément . Suivre les directives fournies par le manufacturier des tuyaux d’alimentation pour une installation adéquate . QK043G...
  • Page 21: Installation Sur Le Comptoir

    Installation (suite) INSTALLATION SUR LE COMPTOIR PRÉPARER LA SURFACE DÉCOUPE DU COMPTOIR REMARQUE : AVERTISSEMENT : Toujours porter des lunettes et des Les éviers installés par le dessus sont déposés sur le comptoir à gants de sécurité afin d’éviter les blessures. partir du dessus.
  • Page 22 Les tuyaux d’alimentation qui raccordent le robinet au système d’eau résidentiel ne sont pas fournis avec cette unité . Ils doivent être achetés séparément . Suivre les directives fournies par le manufacturier des tuyaux d’alimentation pour une installation adéquate . QK043G...
  • Page 23: Installation De La Crépine À Rebord Infini

    Installation (suite) INSTALLATION DE LA CRÉPINE À REBORD INFINI REMARQUE : Si vous installez un broyeur à déchets (non inclus), n’installez pas la crépine. Vous devez acheter un adaptateur spécial pour remplacer la bride de votre broyeur à déchets. Vous pouvez vous procurer l’adaptateur auprès du fabricant. Installez le broyeur à déchets selon les instructions du fabricant, en remplaçant la bride par l’adaptateur.
  • Page 24: Soin Et Nettoyage

    Lorsque vous avez terminé, rincez l’évier avec de l’eau et essuyez-le à l’aide d’une serviette pour permettre qu’une couche externe protectrice se forme. Vous pouvez également utiliser cette procédure pour redonner à toutes les surfaces de l’évier leur éclat. QK043G...
  • Page 25: Pièces De Rechange

    Pièces de rechange Si des pièces sont manquantes ou si vous avez besoin de pièces de rechange, veuillez nous contacter au cs@conglomkb.com ou 1-877-333-0098 (lundi au vendredi, 8 h 30 à 17 h, HNE). Veuillez identifier les pièces nécessaires et ayez les codes à portée de main. Pièce Description Code Quantité...
  • Page 26 Imported by / Importé par : St-Laurent, Québec, H4S 2C3 1-877-333-0098 | cs@conglomkb.com (service available in English and French, Monday - Friday from 8:30 am - 5 pm EST) (service disponible en anglais et en français, du lundi au vendredi, 8 h 30 à 17 h, H.N.E.) www.conglomkb.com Made in China / Fabriqué...

Table of Contents