JVC KD-DV7406 Installation And Connection Manual page 4

C
Connecting the parking brake wire
When installing the monitor in a location
where it can be seen by the driver
Connect the parking brake wire to the parking brake
system built in the car.
When installing the monitor in a location where
it cannot be seen by the driver
Connect the parking brake wire to metallic body or
chassis of the car.
D
Connecting the crimp connector
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire to this point.
E
Required connections for DVD/AV-IN (video) playback
or
Rear side
KV-MR9010
9-INCH WIDESCREEN MONITOR * 6
F
Connecting the external components
When connecting the external components, refer also to the manuals supplied for the components and
adapters.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component
CD changer (CD-CH)
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component
Bluetooth device
iPod
Portable audio player with line output jacks
Portable audio player with 3.5 mm stereo
mini jack
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained on the right column.
You can also connect an external component to the LINE IN terminals on the rear of the unit using a signal cord (not supplied).
LINE IN terminals
* 6 Not supplied for this unit.
* 7
To listen to disc playback sound while in Dual Zone operations (see page 25 of INSTRUCTIONS).
8
*
To use these components, set the external input setting correctly (see page 42 of the INSTRUCTIONS).
Parking brake
Parking brake switch (inside the car)
* 6
Signal cord
Video cord
KS-HP2 *
6
* 7
Cordless headphones
Model name
CH-X1500, etc.
Adapter Model name
Bluetooth adapter KS-BTA200
Interface adapter for iPod KS-PD100
Line input adapter KS-U57
AUX input adapter KS-U58
Parking brake wire (light green)
Contact the metallic part of the crimp to the wires inside.
* 6
Digital optical cable
When connecting two components in series
A KS-BTA200
B *
8 CD-CH / KS-PD100 / KS-U57 / KS-U58
To disconnect the connector
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
* 6
Signal cord
4
Parking brake wire (light green)
To metallic body or chassis of the car
Pinch the crimp firmly.
* ( )
6 only for DVD playback
Audio/video control amplifier or the decoder
compatible with the multichannel digital sources
CD changer jack
Hold the connector tightly ( 1 ), then pull it out ( 2 ).
External component
* 8