D-Link DCS-G900 Install Manual page 9

DCS-G900 Install Guide
To run the Setup Wizard, click on: Start >Programs >D-Link Setup Wizard.
Your camera's IP Address will Your camera's IP Address will
be displayed here along with its be displayed here along with its
corresponding MAC Address. corresponding MAC Address.
Click Wizard Click Wizard
You must change the Admin ID and
Password immediately to protect your
camera against unauthorized access.
By default, the Admin ID and Password
are blank. To change the Admin ID and
Password, select both Change boxes and
enter a New ID and New Password.
Click Next Click Next
Enter an IP Address and Subnet Mask
for your camera if you want to change
the current settings. Enter your Gateway
and DNS settings. These settings must
correspond with your network settings
for you to access the camera. If you are
unsure of what these settings should be,
check with your network administrator.
Click Next Click Next
D-Link Systems, Inc.
Configuration
9