Advertisement
- Only use the power cord and other
accessories supplied with the product.
- Do not attempt to open the product to
remove or replace the built-in
rechargeable battery.
IMPORTANT: The power plug contains a
transformer. Do not cut off the power plug
to replace it with another plug as this will
cause a hazardous condition.
SAVE THESE
INSTRUCTIONS
Introduction
Congratulations on your purchase and
welcome to Philips Norelco!
To fully benefit from the support that
Philips Norelco offers, register your product
at www.norelco.com/register.
General description (Fig. 1)
1 Precision shaver
2 Precision trimmer
3 Nose trimmer
4 Full-size hair trimmer
5 On/off slide
6 Socket for small plug
7 Stubble guard 3/64in. (1mm)
8 Stubble guard 5/64in. (2mm)
9 Beard guard 1/8in. (3mm)
10 Beard guard 3/16in. (5mm)
11 Beard guard 9/32in. (7mm)
12 Hair guard 3/8in. (9mm)
13 Hair guard 15/32in. (12mm)
14 Hair guard 21/32in. (16mm)
15 Eyebrow guard 1/4in. (6mm)
16 Power plug
17 Small plug
Not shown: cleaning brush and pouch
This symbol indicates that the product can
be rinsed under running tap water.
Charging
When the product has charged for 16 hours,
it has a cordless operating time of up to 80
minutes.
- Charging, recharging or using the product
at temperatures below 40°F (4,5°C) or
higher than 95°F (35°C) adversely affects
the lifespan of the battery.
- If the product is subjected to a major
change in temperature, pressure or
humidity, let the product acclimatize for
30 minutes before use.
1 Make sure the product is switched off.
2 Insert the small plug into the product and
put the power plug in any 120V AC outlet
(Fig. 2).
3 After charging, remove the power plug
from the wall outlet and pull the small
plug out of the product.
Note: An adapter plug may be necessary for
cord usage in some foreign countries. Use
an attachment plug adapter of the proper
configuration for power outlet.
Using the product
Note: This product can be used without
cord or directly from the power outlet.
Note: Switch off and clean the product and
attachments after each use.
- Use this product for its intended
household use as described in this
manual.
- For hygienic reasons, the product should
only be used by one person.
Detaching and attaching cutting elements
1 To detach a cutting element, push
upwards against the teeth of the cutting
element and take it off the handle (Fig.
3).
2 To attach a cutting element, insert the
lug of the cutting element into the
guiding slot at the front and push the
back of the cutting element onto the
product ('click') (Fig. 4).
Detaching the nose trimmer
1 Place your finger on the arrow at the
back of the attachment and push it off
the handle in the direction of the arrow
(Fig. 5).
Advertisement
