Table of Contents
Advertisement
This chapter provides the information on how to install the hardware
using the HS-7165. This chapter also contains information related to
jumper settings of switch, and watchdog timer selection etc.
3.1
Before Installation
After confirming your package contents, you are now ready to install
your hardware. The following are important reminders and steps to
take before you begin with your installation process.
1.
Make sure that all jumper settings match their default settings
and CMOS setup correctly. Refer to the sections on this chapter
for the default settings of each jumper. (JP4 short 1-2)
2.
Go through the connections of all external devices and make
sure that they are installed properly and configured correctly
within the CMOS setup. Refer to the sections on this chapter
for the detailed information on the connectors.
3.
Keep the driver CD in good condition for future reference and
use.
Chapter 3
Hardware Installation
7
Advertisement
Table of Contents
