ADT Ademco Vista 20 Quick Manual

Quick Guide:

For a detailed review of the entire system, please view the

Arm and Disarm

Arm:

To arm in STAY mode, when you are not leaving the premises, enter your [security code] + [3].



To arm in AWAY mode, when you are leaving the premises, enter your [security code] + [2].



To arm in MAXMIMUM mode, when no one will be in or around the premises for long periods of time,



enter your [security code] + [4].

Disarm:

To disarm, enter you're security code] + [1].



The Ademco Vista 20 operates on a UB 1270 battery.



Loss of AC power and use of backup battery power is indicated by NO AC.



Ademco Vista – 20

Ademco Vista – 20 system manual.

Table of Contents

Do you have a question about the Ademco Vista 20 and is the answer not in the manual?

Page 1 [security code] + [4]. Disarm: To disarm, enter you’re security code] + [1].  Battery The Ademco Vista 20 operates on a UB 1270 battery.  Loss of AC power and use of backup battery power is indicated by NO AC. ...
Page 2 A low battery condition is indicated by BAT.  For instructions on replacing your battery, please visit our Battery Replacement Page.  Bypassing Protected Areas Bypassing a zone allows you to arm your system with certain protected areas intentionally unarmed or to access a protected area when the system is armed.
Page 3 Security Codes Your system will allow different security codes for use by other users, however only the Master user or Partition Programmer can assign user codes to users. Users are also assigned an Authority Level, which defines the functions a particular user can and cannot perform.