Setting Radio Presets - capello CR60 User Manual

desired station appears on the display.
Notes: Fully extend the FM antenna wire to increase reception sensitivity.
Keep digital music players or mobile phones away from the FM antenna as this may
cause interference. Do not place the FM antenna near the AC power adaptor as this
may lead to reception interference.

Setting radio presets

1. To preset a radio station to memory, first follow the steps above to tune in the
desired station.
2. Press and hold the PLAY / RADIO PRESET button to create a preset for the current
station. "P" will appear and "##" (the preset number) will blink on the display.
3. Press the TUNE UP / MIN or TUNE DOWN / HOUR button to select a preset
number (01- 10). Press the PLAY / RADIO PRESET button again to confirm the
setting and the station will be saved into memory.
4. Repeat these steps for up to 10 presets, as desired.
5. To recall a preset station, repeatedly press the PLAY / RADIO PRESET button until
the desired preset number appears in the display and the station tunes in.
Note: Saving a new station preset in the same position as a previously saved station
will replace the previously stored station for that preset number.
Bluetooth Operation
You can stream audio wirelessly to CR60 from up to 33' away using your iPhone, iPad,
iPod, Android, laptop, or other A2DP Bluetooth enabled device.
1. Press the POWER ON/OFF button to turn on CR60.
2. Then press the SOURCE or BLUETOOTH PAIR / TIME SET button. The
Bluetooth LED indicator will flash on the display.
3. Turn on your A2DP Bluetooth device and enable Bluetooth.
4. Search for Bluetooth devices and select "CR60".
5. The Bluetooth LED indicator will change from flashing to solid indicating that your
Bluetooth device is connected to CR60.
Notes:
- Press and hold the BLUETOOTH PAIR / TIME SET button for 3 seconds to
disconnect the Bluetooth connection.
- The unit will return to pairing mode and the Bluetooth LED indicator on the display
will flash.
- If asked for a password, enter "0000".