Table of Contents
Advertisement
Event ID code
Cause and solution
0023
Connection failed. If you see the PIN entry screen on your computer, enter the PIN
code displayed on the Screen Mirroring standby screen or at the bottom right of the
0024
projected image. If this does not solve the problem, restart the projector and
0025
connected devices, then check the connection settings.
0038
Wireless LAN system mismatch. Check the wireless LAN settings for the mobile
device and projector, then try connecting again.
0042
0041
Connection failed. Delete the recorded projector information on your computer and
try connecting again.
0043
The video format is not supported. Change the resolution of the mobile device, and
then reconnect. Or change the Screen Mirroring Settings > Basic > Adjust Image
Quality setting for the projector, and then reconnect.
0432
The network software did not start. Turn the projector off and then on again.
0435
0433
Cannot display the transferred images. Restart the network software.
0434
Unstable network communication. Check the network communication status, wait a
few moments, and try connecting to the network again.
0481
0482
0485
0483
The network software quit unexpectedly. Check the network communication status,
then turn the projector off and then on again.
04FE
0484
Communication with computer was disconnected. Restart the network software.
0479
A projector system error has occurred. Turn the projector off and then on again.
04FF
0891
Cannot find an access point with the same SSID. Set your computer, access point,
and projector to the same SSID.
0892
The WPA/WPA2 authentication type does not match. Make sure the wireless
network security settings are correct.
0893
The WEP/TKIP/AES encryption type does not match. Make sure the wireless
network security settings are correct.
158
Advertisement
Table of Contents
