Related Manuals for Horizon Hobby Cirrus SR22T
Summary of Contents for Horizon Hobby Cirrus SR22T
- Page 1 Cirrus SR22T Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni ® SAFE Select Technology, Optional Flight Envelope Protection...
- Page 2 NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage, and serious injury OR create a high probability of superfi...
-
Page 3: Table Of Contents
Box Contents Quick Start Information Transmitter Set up your transmitter using the Setup transmitter setup chart Hi Rate Low Rate 25mm 15mm 25mm 15mm Dual Rates 11mm 16mm 10mm Landing Takeoff Flaps =30mm =15mm Center of 63.5mm +/-3mm back from leading edge Gravity (CG) of wing at the fuselage. -
Page 4: Select Technology
4. Go to the FUNCTION LIST DX7 (Gen2) DX8 (Gen2) 5. Set FLAP SYSTEM: SELECT SWITCH D: POS 0: 100% FLAP DX10t POS 1: 0% FLAP 4% Elevator POS 2: -100% FLAP 6% Elevator DX18 SPEED 2.0 DX20 Cirrus SR22T... -
Page 5: Model Assembly
Model Assembly Landing Gear Installation Main Gear 1. Install the landing gear assemblies (A) into the mounting locations on the sides of the fuselage as shown. 2. Secure the landing gear into place with the 4 included 3 x 8mm screws (B) as shown. -
Page 6: Transmitter And Receiver Binding / Safe Select
If the receiver loses transmitter communication, the failsafe will activate. When activated, failsafe moves the throttle channel to its preset failsafe position (low throttle) that was set during binding. All other channels move to actively level the aircraft in fl ight. Cirrus SR22T... -
Page 7: Battery Installation And Esc Arming
Battery Installation and ESC Arming Battery Selection ® The E-fl ite 2200mAh 11.1V 3S 30C Li-Po battery (EFLB22003S30) is recommended. Refer to the Optional Parts List for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dimensions and weight of the E-fl... -
Page 8: Model Assembly Continued
After binding a transmitter to the aircraft receiver, set the trims and sub-trims to • Turn the linkage 0, then adjust the ball links to center the control surfaces. clockwise or counterclockwise until the control surface is centered. • Attach the linkage to the servo arm or control horn after adjustment. Cirrus SR22T... -
Page 9: Scale Accessories Optional
Scale Accessories Optional Scale accessories are each held in place with a single 2 x 6mm self tapping screw. 2 x 6mm self-tapping button head ® SAFE Select Switch Designation SAFE ® Select technology can be easily assigned to any open switch (2 or 3 Mode 1 and 2 Transmitters position) on your transmitter. -
Page 10: Center Of Gravity (Cg)
fl ight path. After adjusting the trim, do not touch the control sticks for 3 seconds. This allows the receiver to learn the correct settings to optimize AS3X performance. Failure to do so could affect fl ight performance. Cirrus SR22T... -
Page 11: Flying Tips And Repairs
Flying Tips and Repairs Consult local laws and ordinances before choosing a fl ying location. Once on the ground, avoid sharp turns until the plane has slowed enough to prevent scraping the wingtips. Range Check your Radio System NOTICE: If a crash is imminent, reduce the throttle WARNING: and trim fully. -
Page 12: Post Flight
Incorrect response Incorrect direction settings to the AS3X Control in the receiver, which can DO NOT fl y. Correct the direction settings (refer to the receiver manual), then fl y Direction Test cause a crash Cirrus SR22T... -
Page 13: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution Throttle not at idle and/or throttle trim too high Reset controls with throttle stick and throttle trim at lowest setting Aircraft will not re- Throttle servo travel is lower than 100% Make sure throttle servo travel is 100% or greater spond to throttle but responds to other Throttle channel is reversed... -
Page 14: Ama National Model Aircraft Safety Code
(b) An inexperienced pilot is assisted by an experienced pilot. 4. When and where required by rule, helmets must be properly worn and fastened. They must be OSHA, DOT, ANSI, SNELL or NOCSAE approved or comply with comparable standards. Cirrus SR22T... -
Page 15: Limited Warranty
Product, (iv) attempted service by offi ce. anyone other than a Horizon Hobby authorized service center, (v) Product not Warranty Requirements purchased from an authorized Horizon dealer, or (vi) Product not compliant... -
Page 16: Contact Information
Compliance Information for the European Union EU Compliance Statement: Horizon Hobby, LLC hereby declares that this product is in compliance with the essential requirements and other relevant provisions of the RED and EMC Directives. A copy of the EU Declaration of Conformity is available online at: http://www.horizonhobby.com/content/support-render-compliance. -
Page 17: Replacement Parts
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambio Part # | Nummer Description Beschreibung Description Descrizione Numéro | Codice Nur Rumpf/Haube und Fuselage/capot et trappe de Fusoliera/cappottatura e solo Fuselage/ cowling and servo EFL5951 Servo-Abdeckung (nicht die servo uniquement (Pas trappe sportello servocomando (non hatch only (Not cabin hatch) -
Page 18: Optional Parts
Spektrum DX18 DSMX 18 Kanal Sender Emetteur DX18 DSMX 18 voies DX18 DSMX Trasmettitore 18 canali DX20 DSMX 20-Channel Transmitter Spektrum DX 20 DSMX 20 Kanal Sender Emetteur DX20 DSMX 20 voies DX 20 DSMX Trasmettitore 20 canali Cirrus SR22T... - Page 19 E-fl ite, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, Z-Foam, Passport, Prophet, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Need help?
Do you have a question about the Cirrus SR22T and is the answer not in the manual?
Questions and answers