Advertisement
IN NO EVENT SHALL SELLER OR MANUFACTURER BE
Before drilling please check that no cable or wiring is on the other side
LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF
of the wall. Please clamp all wires securely to reduce the possibility
ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM
of them being damaged while vehicle is in use. Keep all cables away
ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
from hot or moving parts and electrical noisy components.
We recommend doing a benchmark test before installation
to insure that all components are working properly.
Step 1: Choose the monitor and camera locations.
Step 2: Install all cables in vehicle, when necessary a 0.8 (20mm)
hole should be drilled for passing camera cable through vehicles
walls. Install split grommets where applicable.
Step 3: Once all cables and wiring have been properly routed, perform
a system function test by temporarily connecting the system. If the
system seems to not be operating properly see troubleshooting (page
17).
6
7
Rear View Safety
Reverse With Confidence ™
Advertisement
