Replacement Of Batteries; Repair Service; Warranty; Guarantee Regulations - MULTI MEASURING INSTRUMENTS 340 Instruction Manual

CAUTION:
This tester is designed for low voltage applications.
To avoid electrical shock or damage, the measurement is limited to the
circuit under 600V AC and 60A AC.
Never make measurements for uninsulated conductors or bus bars.

6. REPLACEMENT OF BATTERIES

When the battery becomes exhausted or drops below the operating voltage, the "B"
mark is displayed. Turn the power switch to "OFF", prior to installing batteries.
To install the batteries, remove the battery cover located on the unit back.(See Fig.2)
Insert the two LR-44 or SR-44 into the battery case making sure that proper
polarity is observed. (See Fig.3)
Always replace both batteries at the same time. If the difference between the
voltages of the batteries is big, the measurement error may be caused.
Battery Cover Screw
The correct size screw
must be used and fitted
to ensure battery cover
security, and
operation.

4. REPAIR SERVICE

When requesting for repair service, please bring the instrument directly to the dealer where you bought.
When mailing the instrument, always pack it in its original or equivalent packing materials to avoid any
damage during the transportation and also put together with documents showing your name, address,
phone number and defect point.

5. WARRANTY

This instrument is sent out from our factory after the sufficient internal inspections but if you find any
defect due to the fault in our workmanship or the original parts, please contact the dealer where you
bought the instrument.
The warranty period is 12 months from the date of purchase and the instrument shall be repaired at free of
charge, provided that we judge the cause of defect is obviously resulted from our responsibility.
GURANTEE REGULATIONS
1. This instrument is warranted for the operation under normal use for 12 months from the date of
purchase.
2. This warranty does not cover the following defects:
a. Defect caused from the improper use and operation.
b. Defect caused from the use, operation and storage beyond the original specifications, designs and
conditions.
c. Defect caused from the renovations or repairs done by someone else than us or our
representatives.
d. Defect not caused from our responsibilities.
safe