Table of Contents
Advertisement
FLOW CHART NO.13
PON 1.8V is not outputted. (PC 3.3V(1), (2) is possible)
Is 5V voltage supplied at pin(1) of IC1002?
Is voltage of 1.8V sent out from the pin(2) of
IC1002?
Check the IC1002 periphery circuit.
FLOW CHART NO.14
The disc tray cannot be opened and closed.
(For remote control is possible.)
Is 0V voltage supplied at pin(25) of CN1001 when
the OPEN/CLOSE button is activated on the DVD?
Check waveform at pin 3 and pin 4 on IC2001 or replace it.
FLOW CHART NO.15
The disc tray cannot be opened and closed.
Is the signal from the pins(200, 201) of IC601
inputted into the pins(1, 2) of IC401?
Is loading motor drive voltage output from the
pins(9, 10) of IC401?
Is the loading motor drive voltage applied to the
terminal of loading motor?
Check for mechanism and gear engagement and breakage.
FLOW CHART NO.16
The [No Disc] indication. (In case of focus error)
Is FE signal outputted to the pin(22) of IC101
when the disc is set?
Is FE signal inputted into the pin(117) of IC201?
Check or replace IC201?
Check the line between the IC101 and IC201.
1-8-5
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
No
Check the secondary circuit, AT 5V line.
Yes
Check for load circuit short-circuiting of leak.
Yes
Replace IC1002.
No
Check the SW2014 and OPEN/CLOSE KEY line.
No
Check the TFWD/TREV signal line between IC401
and IC601.
Replace IC401.
No
Is 9V voltage applied to the pins (7, 8, 20) of
IC401?
Check PC 8V line.
No
Check the line between the IC401 and the loading
motor.
Replace IC101.
No
Is there input signal on the pins(57~60) of IC101.
No
Check the connection of optical pickup cable.
If it is normal, replace the optical pickup.
Yes
No
Yes
No
Advertisement
Table of Contents
