Kenwood KDC-210UI Instruction Manual page 21

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys
into the holes on both sides of the trim
plate, then pull it out.
3 Insert the extraction keys deeply into
the slots on each side, then follow the
arrows as shown on the illustration.
Do the required wiring.
( 21)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting bracket
and secure the unit with screws (supplied).
The following screws are supplied for:
/ /
Round head screws (M5 × 8 mm)
Flat head screws (M5 × 8 mm)
Sems screws (M4 × 8 mm)
:
Round head screws (Ø5 × 8 mm)
Flat head screws (Ø5 × 8 mm)
Sems screws (M4 × 8 mm)
Use only the specified screws. Using wrong screws might damage the unit.
– – – – – or – – – – –
:
× 4
To secure the mounting
bracket
× 4
To secure the ground
× 1
wire (black)
× 4
To secure the mounting
bracket
× 4
To secure the ground
× 1
wire (black)
ENGLISH
21