BT Freestyle 1050 User Manual page 10

Plug the mains adaptor cord into
4
the back of the base unit
To prevent the cable being pulled out by
accident, route it through the channel on the
underside of the base.
Electrical storm warning
During periods of electrical storm, you are
advised to disconnect your apparatus because
damage may occur.
If a fault occurs during the 12-month warranty
period and it is due to accidental or wilful damage
(including lightning and electrical damage),
BT will not replace or repair free of charge.
Plug the 3 pin adaptor into the
5
mains power socket and switch on
Your Freestyle 1050 begins the set up procedure.
– the message counter flashes ' – – – '.
– the message counter then flashes 0.
– the pre-set outgoing message is ready to use.
6
12V AC
PHONE LINE
Mains power adaptor
The Freestyle 1050 must only be used with the
adaptor supplied.
Using any other adaptor will invalidate the approval
given to this apparatus.
Charge the handset batter y for at
6
least 12 hours
When you first use your Freestyle 1050, the
rechargeable batteries in the handset need
charging for 12 hours.
Place the handset on the base unit face down,
ensuring the contacts are touching.
The light on the base unit comes ON.
CHARGING
After the handset has been charged for 12 hours,
your phone is ready for use.
As a rule, placing the handset on the base unit
overnight will keep the batteries fully charged
for all normal use.
The light remains on until the
CHARGING
handset is removed from the base unit.
When fully charged and in good condition,
the handset battery will provide up to 6 hours
continuous talk time or 72 hours standby.
If the handset battery is running low, the
light will f lash every 10 -15 seconds.
BATTERY LOW
If you are making a call and the handset
battery is running low, the phone will beep every
10 -15 seconds.
Place the handset on the base unit to recharge.