Advertisement
Quick Links
Operating Instructions • Warning Information • Parts
Breakdown
9004
SPECIFICATIONS
G
F
Fluid Orifice .......................................................... 1.4mm
RAVITY
EED
Air Inlet: ....................................................................1/4 NPT
S
G
PRAY
UN
Rec. Max. Inlet Pressure: ..............................................50 PSI
& C
UP
CFM: ................................................................ 3.1 at 50 PSI
Nozzle Pressure .......................................................... 10 PSI
1
Rev. 02/22/02
Advertisement
Related Manuals for Sunex Tools 9004
Summary of Contents for Sunex Tools 9004
- Page 1 Operating Instructions • Warning Information • Parts Breakdown 9004 SPECIFICATIONS Fluid Orifice ............1.4mm RAVITY Air Inlet: ..............1/4 NPT PRAY Rec. Max. Inlet Pressure: ..........50 PSI & C CFM: ..............3.1 at 50 PSI Nozzle Pressure ............10 PSI Rev. 02/22/02...
- Page 2 WARNING - FOLLOW THESE RULES FOR SAFE OPERATION! • During cleaning and flushing, solvents • When possible, secure work with clamps or vise so can be forcefully expelled from fluid both hands are free to operate tool. and air passages. Some solvents can •...
-
Page 3: Installation
AIR SUPPLY Length of Pipe (ft.) Pitch pipe back toward air receiver Air Flow 1/2" 3/4" 3/4" Compressor Unit Install drain at 3/4" 3/4" 3/4" 3/4" each low point 3/4" 3/4" 1" 1" 1" 1" 1" 1" Oil & Water 1"... - Page 4 FOR BEST PERFORMANCE, PLEASE BE SURE TO DO THE FOLLOWING BEFORE USING THIS TOOL • Tighten the gun to the cup securely with the nut and fitting supplied. • Be sure to have the proper air pressure at the gun to operate. Proper air pressure for this tool should be 35 PSI for lacquer and 50 PSI for enamel.
-
Page 5: Operation
OPERATION Proper handling of the gun is essential for obtaining a uniform finish, lap each stroke over the preceding stroke, good finish. The gun should be held at a right angle to making sure the spray is smooth and wet. the surface being covered, and moved parallel with it. -
Page 6: Troubleshooting
TROUBLESHOOTING SPRAY PATTERN/ PROBLEM SOLUTION CONDITION Soak nozzle in solvent to loosen clog, then blow One side of nozzle wing air through until clean. To clean orifices use a is clogged. broom straw or toothpick. Never try and detach dried material with sharp tool. A.) Loose air nozzle. - Page 7 PARTS BREAKDOWN - 9004 600CC 1732 1729AL-1 1730A 1731 9003PKG (10 Pack) 9612N-0 1709 1710 1701 1717 1718 1719 1704 1705 1706 1707 1708 1711 1716 1713 1726 1724A 1714 1733 1722 1715 1720 1725A 1700RK Includes all parts as...
- Page 8 PARTS LIST - 9004 ITEM NO. DESCRIPTION 1700RK Repair Kit* 1701 Air Nozzle 1.4MM (Standard) 1704 Fluid Nozzle 1.4MM (Standard) 1705 Packing Screw 1706 Teflon Seal 1707 Washer 1708 Spring 1709 Brass Baffle (Left-Hand Thread) 1710 Gasket 1711 Connector 1713...