Tooth Cutting Angle; Table Of Cutting Speed According To Disk Diameter - Thomas 275 SUPER CUT Use And Maintenance Manual

9.7.1 - RECOMMENDED CUTTING PARAMETERS
CUTTING ANGLES
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
*T mm
Vt m/1'
Av mm/1'
RECOMMENDED LUBRIFICANTS
9.7.2 - DIAGRAM OF CUTTING SPEEDS ACCORDING TO DISK DIAMETER
Vt m/min
KEY
T Tooth pitch in millimetres
Av mm/min Advance in millimetres per minute
Vt m/min Cutting speed in metres per minute
Az Tooth advance
Ng/min Number of revs per minute
Z Number of teeth on the disk
p Tooth depth
12
Emulsion - Cutting oil
Kerosene
Dry Emulsion
Dry
d Diameter of the tooth fillet cone distance
h Tooth protrusion
γ
Front rake
α
Rear rake
N/mm Ultimate tensile stress
a-f Flat parts of the cutting edge
Ø Tube diameter or profile width
SUPER CUT SUPER CUT SUPER CUT
SUPER CUT SUPER CUT
Cutting oil Emulsion
n = g/min