Zanussi ZOP37901 User Manual page 21

CAUTION!
If there are other appliances installed
in the same cabinet, do not use
them when the Pyrolysis function
operates. It can cause damage to
the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn from
the hot air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
4. When flashes, press
the necessary procedure:
Option
P1
P2
You can use the End function to delay the start
of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set temperature, the
door locks. The display shows the symbol
and the bars of the heat indicator until
the door unlocks.
To stop Pyrolysis before it is completed,
turn the knob for the oven functions to the
off position.
6. When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
Cleaning reminder
To remind you that the Pyrolysis is necessary,
PYR flashes in the display for 10 seconds after
each activation and deactivation of the
appliance.
www.zanussi.com
or to set
Description
If the oven is not
very dirty. Time
of the proce-
dure: 1 h.
If you cannot
easily remove
the dirt. Time of
the procedure: 1
h 30 min.
The cleaning reminder goes out:
• after the end of the Pyrolysis
function.
• if you press
same time while PYR flashes in
the display.
Cleaning the oven door
The oven door has three glass panels.You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION!
Do not use the appliance without the
glass panels.
Open the door fully
1
and hold the two
door hinges.
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
and at the
Lift and turn the
2
levers on the two
hinges.
Put the door on a soft
4
cloth on a stable
surface.
21