Yamaha GRIZZLY 350 YFM35FGZ Owner's Manual page 93

Table of Contents

Advertisement

1. Engine oil dipstick
2. Maximum level mark
3. Minimum level mark
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
NOTICE: Be sure the engine oil is at the
correct level, otherwise engine damage
may result.
[ECB00851]
6. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1. Place the ATV on a level surface.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Place an oil pan under the engine to collect
the used oil.
4. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
1. Engine oil drain bolt
TIP
Skip steps 5–7 if the oil filter cartridge is not being
replaced.
5. Remove the oil filter cartridge with an oil filter
wrench.
8-13
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grizzly 350 yfm350faz

Table of Contents