Toasting Tips; Single Slice Toasting - Breville VTT714 Instructions Manual

loading handle upwards beyond its rest
position to help you remove the toast.
4. If the toast is not done enough it can
be toasted again. Turn the browning
control to a lower setting and watch the
toast to ensure that it doesn't burn.
5. Toasting can be stopped at any time by
pressing the cancel button.

TOASTING TIPS

• Toasting is a combination of drying
and cooking the bread and, because
moisture levels differ from one bread to
another, toasting times can vary.
• For slightly dry bread, use a lower
setting than normal.
• For fresh bread or whole wheat bread,
use a higher setting than normal.
• Bread which has a very uneven surface
will require a higher setting.
• Thicker cut pieces of bread (including
crumpets) will take longer to toast—
sometimes significantly longer. This
is because more moisture must be
evaporated from the bread before
toasting can occur. Very thick pieces of
bread may require two toasting cycles.
• When toasting raisin or other fruit
breads, remove any loose raisins or
fruit from the surface of the bread
before putting it into your toaster. This
will help prevent fruit pieces from falling
into your toaster or sticking to the guard
wires in the toasting slot.

SINGLE SLICE TOASTING

If you are toasting a single slice of bread,
set the browning control to a lower setting
than normal. By using a lower setting when
toasting a single slice of bread, it will not
be over toasted.
IF YOUR TOASTER JAMS
Never use a knife or any other
utensil or implement to remove jammed
bread. Never insert your fingers into the
bread slots.
1. Switch the toaster off at the mains
supply socket and unplug it.
2. Allow the toaster to completely cool
down.
3. Carefully ease the bread out of the
toaster being careful not to damage the
heating element.
CLEANING
Always switch off, unplug and allow
the toaster to cool down before moving,
cleaning or storing. Never immerse the
toaster or power cord and plug in water
or any other liquid.
• Clean the outside of your toaster with a
damp cloth then dry thoroughly.
• Never use harsh, abrasive or caustic
cleaners.
CRUMB REMOVAL
It is important that crumbs are not
allowed to build up inside your toaster.
Excess crumbs are unhygienic and
could catch fire.
Crumbs can be removed by sliding the
crumb tray out from the bottom of your
toaster. You can then tip the crumbs
out. Always make sure that your toaster
has completely cooled down and is
disconnected from the mains supply before
removing crumbs. Never use your toaster
without the crumb tray fitted. Always
replace the crumb tray before using your
toaster.
5