Table of Contents
Advertisement
5. Insert the screw
1
tighten the screw to secure the monitor stand.
Figure 14. Installing the tilt-only monitor stand to the base
6. Insert the two hooks
cover as shown. Then, pivot the tilt-only monitor stand downward until it snaps into position.
Figure 15. Installing the tilt-only monitor stand to the computer cover
Replacing the UltraFlex II Stand
To replace the UltraFlex II Stand, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
on the base into the corresponding hole in the new tilt-only monitor stand. Then,
1
on the new tilt-only monitor stand into the corresponding holes in the computer
.
Chapter 7
Installing or replacing hardware
53
Advertisement
Table of Contents
