Table of Contents
Advertisement
POWERING THE CAMCORDER ON
INSTALLING THE BATTERIES
1)
Remove the battery compartment cover.
2)
Insert the batteries properly into your digital camcorder, according to the polarity shown
inside the battery compartment.
Use 3 x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
3)
Close the battery compartment cover securely.
Note:
Remove the batteries from the camcorder when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
Some camcorder features (i.e. Flash) will not work if the battery power level is low.
When the battery power is low, the battery icon appears empty and 'Battery Low'
appears on the LCD screen. The camcorder automatically turns off a few seconds later.
The energy status of the power is displayed on LCD as shown below:
Full battery power
INSTALLING THE SD CARD
Make sure the SD Memory card (up to 32GB) has been properly inserted into your digital
camcorder. SD Memory card not included. To properly insert the SD Card:
1)
Push the SD card into the slot in the direction shown on the digital camcorder.
2)
Push the SD card until you hear a slight clicking sound. This indicates the SD card has been
inserted correctly.
Note:
After the digital camcorder is powered on, an SD icon appears on the LCD display. If
you do not see the SD icon on the display, please check if the card was inserted
properly.
Make sure the SD card is not locked (check the lock switch on the side
of the SD card). If the SD card is locked this will prevent the digital
camcorder from saving captured photos to the SD card.
Medium battery power
5
Low battery power
Advertisement
Table of Contents
