Table of Contents
Advertisement
3. Slide the bag support rod through the second
from the top mounting holes in the handle and
secure each end with a cap locknut (Figure 3).
4. Use a cable tie to secure the control cables to
the left handle below the bag support rod.
Step
2
Installing the Fuel Tank and
the Fuel Line
Parts needed for this step:
2
Self-tapping screw
1
Fuel tank
Procedure
1. Start the 2 self-tapping screws into the bottom
of the fuel tank and then remove the screws
(Figure 4).
Figure 4
1. Tank base
2. Fuel tank bracket
3. Plastic clips
2. Hook the plastic clips on the front of the fuel
tank onto the fuel tank bracket (Figure 4).
3. Secure the fuel tank to the tank base with
the 2 self-tapping screws (Figure 4). Do not
overtighten the screws.
4. Fuel tank
5. Self-tapping screw (2)
4. Remove the red cap from the end of the fuel
line and from the end of the elbow fitting on
the fuel tank (Figure 5).
Figure 5
1. Fuel line
2. Elbow tting
5. Slide the end of the fuel line onto the elbow
fitting (Figure 5).
6. Secure the fuel line in place with the fuel line
clamp (Figure 5).
Step
3
Installing the Discharge
Tunnel Plug
Parts needed for this step:
1
Discharge tunnel plug
Procedure
1. Open the discharge door by pulling forward on
the handle and moving it rearward (Figure 6).
Hold the discharge door handle to prevent the
spring-loaded door from closing while you
insert the plug.
9
3. Fuel valve
Advertisement
Table of Contents
