Filling The Engine With Oil; Checking The Tire Pressure - Toro power max 828 OE Operator's Manual

1. Cable clip
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
4. Connecting the Wire to the
Headlight
1 Cable tie
Procedure
1. Insert the wire connector on the loose end of the
wire straight into the back of the headlight until it is
securely in place (Figure 12).
1. Plastic clip on wire
connector
2. U-bolt
Note: Ensure that the plastic clip on the wire
connector is on the bottom (Figure 12).
2. Secure a cable tie (from the loose parts bag) around
the wire and the handle about an inch (2.5 cm) below
the U-bolt (Figure 12).
Figure 11
2. Deflector cable
Figure 12
3. Cable tie

5. Filling the Engine with Oil

Procedure
Your snowthrower comes with 20 oz. of oil in the
engine crankcase.
Note: Before starting the engine, check the oil level
and add oil if necessary.
Max. fill: 20 oz. (0.55 l), type: automotive detergent oil
with an API service classification of SF, SG, SH, SJ, SL,
or higher. Use SAE 5W30 or SAE 10W30 oil. Refer to
your engine owner's manual.
1. Remove the dipstick and slowly pour oil into the oil
fill tube to raise the oil level to the Full mark on the
dipstick. Do not overfill (Figure 13).
2. Install the dipstick securely.
Note: Do not spill oil around the oil fill tube; oil
could leak onto traction parts and cause the traction
to slip.

6. Checking the Tire Pressure

Procedure
The tires are overinflated at the factory for shipping.
Reduce the pressure equally in both tires to between 17
and 20 psi (116 and 137 kPa).
9
Figure 13