Changing The Engine Oil - Toro power max 828 OE Operator's Manual

Checking the Auger Gearbox
Oil Level
Service Interval: Yearly—Check the auger gearbox oil
and add oil if necessary.
1. Move the snowthrower to a level surface.
2. Clean the area around the pipe plug (Figure 40).
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be
at the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP transmission oil to the gearbox until the point
of overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.

Changing the Engine Oil

Service Interval: After the first 5 hours—Change the
engine oil.
Every 50 hours—Change the engine
oil. Change the engine oil every 25
operating hours when operating the
engine under a heavy load.
If possible, run the engine just before changing the
oil because warm oil flows better and carries more
contaminants.
Max. fill: 20 oz. (0.55 l), type: automotive detergent oil
with an API service classification of SF, SG, SH, SJ, SL,
or higher. Use SAE 5W30 or SAE 10W30 oil. Refer to
your engine owner's manual.
1. Clean the area around the oil drain cap (Figure 41).
Figure 40
1. Oil drain cap
2. Slide an oil drain pan under the drain extension and
remove the oil drain cap.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain cap.
5. Fill the crankcase with oil. Refer to Filling the
Engine Crankcase with Oil.
Lubricating the Hex Shaft
Service Interval: Yearly—Lubricate the hex shaft.
Lightly lubricate the hex shaft yearly with automotive
engine oil (Figure 42).
1. Hex shaft
2. Aluminum friction plate
Important: Do not get oil on the rubber wheel
or the aluminum friction drive plate because the
traction drive will slip (Figure 42).
1. Drain the gasoline from the fuel tank.
2. Tip the snowthrower forward onto its auger housing
and block it so that it cannot fall.
3. Remove the back cover (Figure 43).
20
Figure 41
Figure 42
3. Rubber wheel