Adjusting The Cutting Height; Adjusting The Handle Height; Starting The Engine - Toro Recycler 20070 Operator's Manual

Adjusting the Cutting Height

Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury.
•
Stop the engine and wait for all moving parts to stop.
•
Do not put your fingers under the housing when adjusting the cutting height.
If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot
muffler.
Adjust the cutting height as desired. Set all four wheels to the same height.
Note: Only a front cutting height lever is shown.
Figure 13

Adjusting the Handle Height

Squeeze the bottom of the handle halves together and
change the handle holes in which the pins are mounted,
as shown in Figure 14.
Figure 14
1. Pin
2. Use this hole to raise the
handle
3. Use this hole to lower the
handle

Starting the Engine

1. Firmly push in the primer 3 times with your thumb,
holding the primer in for a second before releasing it
each time (Figure 15).
Figure 15
Note: If the air temperature is below 55°F (13°C),
firmly push the primer in 5 times.
2. Hold the blade control bar (Figure 16) against the
handle.
8