ABB M22001 series User Manual page 8

ABB-Welcome M
Function list
No function
Control switch actuator
Intercom call in the same apartment
Intercom call among different
apartments
Call guard unit
Release 2nd-lock of a default
outdoor station (the lock connected
with an outdoor station COM-NC-
NO)
Function code is indicated by flash times of blue LED; if the Blue LED is always on, this
represents code 0.
3. Set the address for each programmable button
Only the following two functions are assigned to the programmable buttons, The
address of each programmable button is needed to be set. Other functions are
inapplicable to this step.
Function 1: Controls switch actuator. Set the address of the switch actuator under
control. The address can be set from 01 to 99.
Function 2: Intercom call among different apartments. Set the address of an indoor
station which is called. The address can be set from 01 to 99.
Hold this programmable button again for 3 seconds until the LED begins to flash
(tens digit or units digit address is other than 0) or lights on (tens digit or units digit
address is 0) to enter the address settings mode.
Press repeatedly to set the tens digit. Each press means one increment to
the previous address. The value is indicated by the flash times of the red LED.
Press repeatedly to set the units digit in the same manner. The value is
indicated by the flash times of the blue LED.
Both tens digit and units digit can be changed in a sequence of: 0->1->2->3->4->5-
>6->7->8->9->0 by pressing
During settings, if the value set is beyond the wanted number, press
tens digit and units digit will go back to the default value 0.
4. Exit the programming mode
Hold this programmable button for 3 seconds until the blue LED & red LED flash
once simultaneously.
Pos: 67 /Di nA4 - A nleitu ngen Onlin e/Ueb ersc hrift en/2 ./Reini gung @ 1 9\m od_ 131 0733 980 533 _15. docx @ 10 785 3 @ 2 @ 1
Pos: 70 /Di nA4 - A nleitu ngen Onlin e/Ueb ersc hrift en/2 ./Ge raet eeins tellun gen @ 1 8\mo d_1 302 768 847 744 _15. docx @ 10 354 8 @ 2 @ 1
|
Function code
0
1
2
3
4
5
or .
Operations
Blue LED flashing
Always on
Flash once
Flash twice
Flash 3 time
Flash 4 time
Flash 5 time
, both
— 8 —