Lights; Installing Pto Belt - Toro 73429 Operator's Manual

Operation
2. Slide the seat to the desired position and tighten
the knobs.
1
Figure 14
1. Adjustment
knobs

Lights

The headlights are turned on with a separate position,
"LIGHTS", of the ignition switch (Fig. 15). The
lights are on while the ignition switch is in the
"LIGHTS" position even with the engine off.
Remove the key when the machine is left unattended
so lights cannot be turned on discharging the battery.
Figure 15
1. Light position

Installing PTO Belt

1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Remove the belt cover.
18
3.
4.
5.
m–4223
6.
7.
1
1. Hairpin cotter
m–3382
2. Trunnion
3. Engagement plate
4. Clevis pin
Remove hairpin cotters from trunnion and
bottom of yoke (Fig. 16).
Unlatch and remove clevis pin that secures yoke
assembly to clutch shaft. Pivot yoke out and
forward to remove from clutch shaft and
engagement plate (Fig. 16).
Place belt in pulley groove, going between
clutch yoke and engagement plate (Fig. 16).
Note: Install belt in inside pulley groove for
mowers and outside pulley groove for
tiller and snowthrower.
Assemble yoke and engagement plate and attach
clevis pin, trunnion and hairpin cotters to secure
(Fig. 16).
Install the belt cover.
1
2
5
4
Figure 16
3
7
6
1
m–3443
5. Yoke
6. Clutch shaft
7. Belt groove