Toro 30280 Operator's Manual page 37

Figure 44
1. Speed control lever
2. Full speed position
3. Neutral position
5. Check the orientation of the tabs on the ends
of the speed control crank. These tabs should
be pointing straight down at the 6 o'clock
position approximately (Figure 45).
6. If adjustment is needed, loosen the nuts on
both sides of the swivel on the speed control
rod (Figure 45).
7. Adjust the swivel until the tabs are at the
6 o'clock position (Figure 45).
8. Tighten the nuts on both sides of the swivel
(Figure 45).
4. Medium speed position
5. Control panel
Figure 45
1. Speed control rod
2. Jam nut
3. Speed control crank
9. Pull the speed control lever back to neutral.
10. Check the travel of the shift lever in the control
panel slot. The shift lever travel should be
approximately centered in the control panel
slot (Figure 44).
11. If needed, adjust the swivel on the speed
control rod to center the shift lever travel
(Figure 45).
12. With the speed control lever in the neutral
position, check to make sure the safety switch
is depressed and there is an 1/8 to 1/4 inch (3
to 6 mm) space between the actuating tab and
the safety switch (Figure 46)..
37
4. Tabs, 6 o'clock position
5. Swivel