Maintenance; Recommended Maintenance; Schedule(S) - Toro 30280 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the rst 8 operating
hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Before storage
Yearly
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wires from the spark plugs
before you do any maintenance. Set the wires aside so that they do not accidentally contact
the spark plugs.
Maintenance Procedure
• Change the engine oil.
• Check the hydraulic uid level.
• Change the hydraulic lter.
• Check the safety system.
• Grease the front caster pivot bearing.
• Check the engine oil level.
• Clean the air intake screen.
• Check the brakes.
• Inspect the blades.
• Clean the mower deck.
• Check the battery electrolyte level.
• Check the hydraulic uid level.
• Grease the side bearings.
• Grease the PTO belt idler.
• Grease the mower deck belt idler.
• Check the tire pressure.
• Check the mower belt.
• Check the PTO drive belt.
• Check the pump drive belt.
• Change the engine oil.
• Check the spark plugs.
• Adjust the electric clutch.
• Check the hydraulic lines.
• Replace the air lter (more often in dirty or dusty conditions).
• Change the oil lter.
• Replace the fuel lter.
• Change the hydraulic lter.
• Grease the front wheel bearings (more often in dirty or dusty conditions).
• Paint chipped surfaces.
• Perform all maintenance procedures listed above before storage.
• Lubricate the caster wheel hubs.
26