Mower Deck Maintenance; Leveling The Mower At Three; Positions - Toro Z149 Z Master 74411 Operator's Manual

Figure 55
1. Double nuts
2. Pump rod
Electrical system will not perform proper
safety shut off with jumper wire installed.
• Remove jumper wire from wire
harness connector and plug
connector into seat switch when
adjustment is completed.
• Never operate this unit with jumper
installed and seat switch bypassed.
7. After both pump neutrals are set, shut off the
machine.
8. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
9. Install the seat rod and lower the seat into
position.
10. Remove the jack stands.
3. Locknut
4. Ball joint
Mower Deck
Maintenance

Leveling the Mower at Three

Positions

Important: There are only three measuring
positions needed to level the mower.
Setting Up the Machine
1. Position mower on a flat surface.
2. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
3. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
4. Check tire pressure of all four tires. If needed,
adjust to 13 psi (90 kPa)
5. Lower the mower to the 3 inch (76 mm)
height-of-cut position.
6. Inspect the four chains. The chains need to
have tension.
Note: Adjust the rear chains to the top of the
slot, where they are attached to the mower.
• If one rear chain is loose, lower (loosen) the
front support arm on the same side. Refer to
Adjusting the Front-to-Rear Mower Pitch.
• If one front chain is loose, raise (tighten) the
front support arm for that chain. Refer to
Adjusting the Front-to-Rear Mower Pitch.
Leveling the Mower Side-to-Side
1. Position the right blade front-to-rear
(Figure 56).
2. Measure the right blade at the B location, from
a level surface to the cutting edge of the blade
tip (Figure 56).
3. Record this measurement. This measurement
needs to be 3-1/8 to 3-1/4 inches.
4. Position the left blade front-to-rear (Figure 56).
5. Measure the left blade at the C location
(Figure 56), from a level surface to the cutting
edge of the blade tip .
6. Record this measurement. This measurement
needs to be 3-1/8 to 3-1/4 inches (79 to
83mm).
44